li ion 18650 battery pack

　　What are the common faults of UPS batteries?

　　There are many common faults of UPS batteries, such as uneven floating charge voltage, battery bulging and deformation, battery leakage, battery water loss, etc. Once the battery discovers these conditions, the battery life will end and needs to be replaced or repaired immediately. Then what follows? Let me introduce the relevant content to you in detail.

　　1. Common faults of UPS batteries

　　1. Unbalanced floating charge voltage

　　Valve-regulated lead-acid batteries commonly have problems with uneven float voltage and open circuit voltage deviation. The uniformity of a valve-regulated lead-acid battery refers to the difference between the open circuit voltage measured after the battery is completed and the float voltage of the battery pack in the float state. Relevant standards stipulate that the difference in the open circuit voltage of each single cell in the battery pack shall not be greater than 20mV, and the difference in the float charge voltage of each single cell in the float charge state shall not be greater than 100mV. If there is a voltage deviation in the battery pack, it will cause early failure of the lagging battery.

　　2. Battery bulging and deformation

　　This is a very destructive phenomenon that occurs when valve-regulated lead-acid batteries are used improperly, that is, thermal runaway, which can cause the battery tank to bulge and deform, accelerate water loss, and even damage the battery.

　　3. Battery leakage

　　Valve-regulated lead-acid batteries will have leakage problems to varying degrees, mainly in battery tank cover leakage, safety valve leakage, and pole terminal leakage.

　　4. Battery loses water

　　Valve-regulated lead-acid batteries work in a "lean" state, and their electrolyte is completely stored in the porous AGM diaphragm. Once the battery loses water, it will cause the positive and negative electrodes of the battery to come out of contact with the electrolyte in the separator, causing the battery to be unable to discharge electricity. The use results show that most of the current reasons for the decline in the capacity of valve-regulated lead-acid batteries are caused by battery water loss. When the water loss reaches 3.5ml/Ah, the battery capacity will drop to less than 75% of the initial capacity; when the water loss reaches 25%, the battery life will be terminated.

　　2. Solution to li ion 18650 battery pack failure to start

　　1. Fully charge the battery.

　　2. Check whether the input AC and DC lines are in good contact.

　　3. Check the UPS startup circuit.

　　4. Check the UPS power circuit.

　　5. Check whether the internal rectifier, boost, inverter and other components of the UPS are damaged.

Read recommendations:

Coin Battery LR 626

Causes of lithium battery detachment.18650 lithium battery 3.7 v

The difference between lithium polymer batteries and lithium batteries.solar energy battery storage

703048 battery wholesaler

1.2V NiMH battery